Installing laminated flooring over cement

Well, worry not, you can simply lay the laminate flooring over the concrete surface. We discuss the proper process for doing the same in the section below, as well as a guideline on how flat your concrete floor should be before laying laminate flooring over it. The steps detailed below will guide you on how to properly install laminate flooring over concrete:. After purchasing your laminate planks, you should store them in the room in which they are to be installed for up to hours before proceeding with installation.

Also, a dry concrete surface helps prevent warping and bubbling of the laminate planks. Meanwhile, you can rid the surface of dirt and debris by sweeping it or vacuuming it. Finally, you need to check how level the concrete surface is using a long level. The troughs, meanwhile, can be filled in using levelling compound.

As such, you need to install underlayment material to act as a vapor barrier before laying down your laminate planks. Failure to do so will lead to increased chances of structural issues like warping in the future. Most commercially available floating laminate floor boards boast a click-lock system, whereby the tongues and grooves on the planks are matched during installation. Installing laminate flooring on uneven concrete Can lead to very displeasing results.

So, make sure you check how level it is beforehand. It should come with no variance on every 10 feet of area. If there is any, you need to mark down those areas. A concrete grinder should help you here. Simply use the tool over any high spots on the concrete subfloor.

Go gradually and grind down those problematic spots. In the case of low areas, you can fill those up using some leveling compound. You want to mix the leveling compound first in a bucket and then apply it using a trowel. Let the applied compound dry properly.

As a result, the adhesive will go weak. And this will cause the flooring planks to warp. So, with a concrete underlay installation , you should think about a laminate floor underlayment that will work as a vapor barrier.

It will keep those moisture prevented from penetrating through laminate flooring. You can go for a plastic vapor barrier that is at least six mm thick. Simply lay it on the concrete subfloor and use some underlayment tape or any seam tape to secure it. You can also include a laminate padding layer on top of this vapor barrier.

So that it does feel more comfortable walking on the floor. Those who are out for a solution that can not only give insulation and underlayment benefits but also heating, moisture-wicking, and even noise defeating advantages, have a look at the Hardwood and Laminate Floor Heating Mat System. Start by placing laminate flooring on top of concrete inside the room. So that the flooring can adjust to room temperature as well as humidity.

You need to keep it that way for at least three days before installation. From first row of laminate flooring, you need to cut the tongue off using a table saw. You need to focus on the first three rows and piece them far from wall. As soon as you are done assembling, you should slide flooring into the spot right next to wall. Using a circular or miter saw cut end pieces. Let the back part of plank in laminate be facing saw while you cut it. Maintain at least 12 inches from one another while staggering joints.

You need to fit the groove and tongue pieces together. Simply insert the tongue at an angle into groove to do so. Use a hammer and tapping block for inserting the tongue in an angle, in case it seems not to work.