Potterton kingfisher mf manual pdf

If the appliance is installed in a compartment, do not use it for storage purposes. Do not obstruct any purpose. If a gas leak or fault is suspected turn off the appliance and consult your Local Gas Region or Service Engineer. Any warning labels on the appliance must be adhered to. The information given in these instructions will help you obtain the maximum comfort from your boiler with the.

Your boiler is fully automatic in operation and requires very little attention apart from. Potterton is a member of the Benchmark initiative and fully supports the aims of the programme. The Benchmark Log Book is an important document and must be. Failure to install and maintain this. Regular skilled servicing is required to maintain the safe and efficient operation of your boiler throughout its. Further information on this subject is given at a later stage.

Kingdom Notified Body. The range is certified to comply with the essential requirements of the Gas Appliance. Warning: This appliance must be earthed.

The appliance must. Warning: Avoid skin contact when the boiler is in operation, as some surfaces may get hot i. The component is fitted to ensure that any blockage or partial blockage of the flue does not result in combustion products discharging into the room. If the flue is not fitted in the fully forward Blanking Plate if required position, the rear blanking plate will need to work surface to be cut to size, cut trim to length as required.

Page 18 9. Slide the flue back until it engages in the elbow bayonet connection, twist clockwise to lock. Drill through pilot hole and lock flue in position using the self tapping screw provided. Make good the wall around the flue, both inside and outside. Page 19 Connect the Gas Supply 1. Ensure that the gas supply is isolated. Disconnect the gas cock from the gas valve.

Connect the gas supply to the gas cock using a suitable adaptor. Important: Do not solder the fitting whilst assembled to the gas cock. Page 20 Connect the Power Supply Cable 1. Cable clamping is provided on the front of the controls panel. Feed the cables up and over the back of the chassis, through clamp into terminal connection.

Note: When connecting the power supply cable, ensure that the length of the earth wire is such, that if the power supply cable pulls out of the cable clamp the live and neutral wires become taut before the Page 21 cable as follows, providing the system has a separate cold feed and vent pipes close coupling is acceptable see BS for further details.

Re-position the overheat thermostat to Gravity DHW position as explained under 2. Page Commissioning 3. Commissioning Important State of adjustment - Check that the state of adjustment given on the data plate is compatible with local supply conditions.

Commission the system 9. With the burner running, check for gas soundness using leak detection fluid. The reset button is located on the controls 1. Examine the system for water leaks and drain assembly, repeated shutdown by this device the system whilst still hot. Page 25 4. Yellow flame and excessive lifting indicate poor combustion.

Page 26 General Access Warning: Before attempting to remove any component from appliance first disconnect the mains electricity supply by removing the plug from the wall socket or by switching off the appliance at the external isolating switch.

Notes: The 'O' stand-by position on the boiler temperature control will leave parts of the boiler Live. Disconnect all connectors and wires, unscrew the two securing screws and remove the board. On re-assembly refer to the wiring diagram when re-connecting wires and connectors. Disconnect the wiring from the gas valve. Remove the combustion chamber cover - 2 screws. Non Domestic Gas Forms. Essential Forms and Pad Sets. Business and Construction Forms. Electrical Forms.

Plumbing Forms. Carry Cases. Boulter Buderus. Heatline Spares. ICI Caldaie. Saunier Duval. Worcester Bosch. Control Box. Expansion Vessel. Oil Filters. Oil Gauges. Oil Lines. Photo Cells.

Tiger Loops. DAB Pumps. EPH Controls. Salamander Pumps. Stuart Turner. You are here: Home Boiler Manuals.